2020+ Toyota GR Supra - Rear Supra Badge Emblem Overlay

If you're looking for an easy way to change the look of your Supra emblem without all the hassle of taking off the badge itself and paying Hundreds of Dollars for a custom painted or hydrodiped emblem. These unique Vinyl overlays have been pre-cut for easy DIY installation and are made with quality automotive grade vinyl, not your typical calendar film found in most decal stickers. Simple Peel and Stick Process saves you time and money. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.

INSTALL GUIDE

TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.

FULL INSTALL: After the surface is clean and you have read and completed "DRY INSTALL BASICS", remove the vinyl from the backing paper. Hold it by the left and right side of the transfer tape and line it up to the letters of the supra badge.

Once placement is confirmed, starting in the center of the emblem, use firm pressure with a pro-felt squeegee or your fingers and lay the center of the vinyl onto the emblem vertically up and down. Then do the same horizontally.

Once the vinyl is laid completely on the emblem, slowly and carefully remove the transfer tape.

Now, post heat the overlay, simply by letting your vehicle sit out in the warm sun for a approximately 30 minutes, or use a heat gun to speed up the process.

SUPERIOR QUALITY

• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.

• Car wash safe.

• Can be removed without any damage to surface.

• 1-3 year life expectancy.

• Check your local laws and regulations

>> DISCLAIMER INFORMATION

DIFFICULTY RATING 2/5

MORE >> Difficulty Rating Information